Westinghouse WP2500 Manual De Propietario

  

27

Required Gasoline – Only use gasoline that meets the 
following requirements:
 Unleaded gasoline only
 Gasoline with maximum 10% ethanol added
 Gasoline with an 87 octane rating or higher

Filling the Fuel Tank – Follow the steps below to fi ll the 
fuel tank:

1.  Shut off the 

pressure washer

.

2. Allow 

the 

pressure washer

 to cool down so all 

surface areas of the muffl er and engine are cool to 
the touch.

3. Move 

the 

pressure washer

 to a fl at surface.

4.  Clean area around the fuel cap.

5.  Remove the fuel cap by rotating counterclockwise.

6.  Slowly add gasoline into the fuel tank. Be very 

careful not to overfi ll the tank. The gasoline level 
should NOT be higher than the bottom of the fi ller 
neck.

Take care when installing the fuel cap. Threads can 
be damaged if cap is incorrectly installed.

7.  Install the fuel cap by rotating clockwise until 

you hear a click, indicating the cap is completely 
installed.

Do not start the engine without the water supply 
connected and turned on. Running the pump without 
water will damage the pump.

Water supply must deliver a minimum of 3.8 gal 
(14.3 L) per minute and at least 30 psi (2 bar). Do 
not siphon standing water for the water supply. Water 
temperature must not exceed 100°F (37.7°C).

1.  Run water through your garden hose to clear out 

any debris that may have been in the hose.

2.  Inspect the water inlet screen to make sure it is in 

place and free of debris (see Figure 31). Do not 
operate the pressure washer with a missing or 
damaged inlet screen.

  1 -  Water Inlet
 Screen

  2 -  Water Inlet
 Fitting