Mazda Remote Starter C930 V7 620 Manual De Usuario
12
Car Find Function
If the car find operation is
performed on the remote control,
the hazard lights will flash twice and
the horn will sound twice so you
can confirm the vehicle’s location.
This function is convenient when
looking for your vehicle in a large
parking lot, etc.
performed on the remote control,
the hazard lights will flash twice and
the horn will sound twice so you
can confirm the vehicle’s location.
This function is convenient when
looking for your vehicle in a large
parking lot, etc.
Answer Back Function
This device conducts bidirectional
communication between the remote
control and the controller (vehicle
side). The user can check the status
of the operations: engine start,
engine stop, warm up time, and rear
defrost, using the LCD monitor on
the remote control.
communication between the remote
control and the controller (vehicle
side). The user can check the status
of the operations: engine start,
engine stop, warm up time, and rear
defrost, using the LCD monitor on
the remote control.
1. The reference operating range of the remote control is approx. 300 ft(91m).
However, this range can be reduced by interference caused by any of
conditions as follows.
conditions as follows.
• There is any obstruction nearby (Buildings, walls, other vehicles, etc.).
• There is any radio wave transmission nearby (television, radio, cellular,
another remote controller, etc.)
• The battery becomes weak.
2. When there is a signal being transmitted that is close to the frequency band
used by this device in the surrounding area, transmission between the remote
control and controller shall be restricted. In this situation, the remote control will
display a send error and/or a receive error.
control and controller shall be restricted. In this situation, the remote control will
display a send error and/or a receive error.
3. When conducting consecutive operations with the remote control switches, wait
“2 seconds or longer” after the “Send mark” on the LCD monitor has turned off,
and then perform the next operation. The operation signal will not be received if
the second operation is performed within 2 seconds of the first.
and then perform the next operation. The operation signal will not be received if
the second operation is performed within 2 seconds of the first.
4. If a send error is displayed, the radio transmission in the area is restricted. Wait
until the display mark turns off before operating the remote control.
5. A receive error may display on the remote control even if the engine has
started, depending on the radio transmission conditions in the area.
Note
Answer back
Send
Remote control
Vehicle side
(Controller)
Car find
Directions for car find
operation → p. 25
operation → p. 25