VTech IP Phone DS6472-6 Manual De Usuario

5

Once you have installed the battery, the screen indicates the battery status 

(see the table below). If necessary, place the handset in the telephone base 

or charger to charge the battery. For best performance, keep the handset in 

the telephone base or charger when not in use. The battery is fully charged 

after 16 hours of continuous charging. See the table on page 103 for battery 

operating times.
If the screen is blank, you need to charge the handset without interruption for 

at least 30 minutes to give the handset enough charge to use the telephone 

for a short time. When the battery is low, the handset shows 

Low battery 

along with a flashing

  . If you are on a call in low battery mode, the handset 

beeps every minute.
The following table summarizes the battery charge indicators and actions  

to take.

Battery indicators

Battery status

Action

The screen is blank, 

or shows 

charger and   flashes.

Battery has no or very 

little charge. The handset 

cannot be used.

Charge without interruption 

until the screen shows 

HANDSET X (at least  

30 minutes).

The screen shows 

Low battery and 

 flashes.

Battery has enough 

charge to be used for a 

short time.

Charge without interruption 

until the screen shows 

HANDSET X (at least  

30 minutes).

The screen shows 

HANDSET X.

Battery is charged.

To keep the battery charged, 

place it in the telephone base  

or charger when not in use.

After you install your telephone or power returns following 

a power outage, the handset will prompt you to set the 

date and time. For instructions, see 

Set date and time  

on page 38. To skip setting, press 

 or 

.

SET DATE

09/30/09

MM/DD/YY

 BACK     SET