VTech IP Phone DS6472-6 Manual De Usuario

107

If you want to replace a handset or headset, or reassign the designated 

handset number of a registered handset, you must deregister all handsets 

and headsets that are registered to the telephone base. Then register each 

handset and/or headset you wish to use individually.
To make deregistration easier, read all of the instructions on this page before 

you begin. 
To deregister all handsets:

Make sure that all handsets are out of the 

telephone base and handset chargers before 

you begin deregistration.
Press and hold 

/FIND HANDSeT on the 

telephone base for about 10 seconds until the 

IN USe light flashes.
Quickly press 

/FIND HANDSeT again. You 

must press 

/FIND HANDSeT while the IN USe 

light is still flashing. The 

IN USe light flashes for about five seconds. If the 

light stops flashing, start again with Step 1 above.
All system handsets show 

Put handset on BASe to register and all 

headset   lights flash slowly and alternately in red and blue. You hear 

a confirmation tone when deregistration completes. The deregistration 

process takes about 10 seconds to complete.

If the deregistration process is successful, you hear “

Not registered” through 

the headset earpiece when you press   on the headset. If deregistration fails, 

you may need to reset the telephone and try again.
To reset:

Press and hold 

oFF/CANCeL or place the handset back in the  

telephone base. 
Pick up the registered headset and press the 

ReSeT inset button with a 

paper clip or similar object.

Unplug the power from the telephone base, then plug it back in.

1.

2.

3.

4.

1.

2.

•

You cannot deregister the handsets and headsets if any system handset or 

headset is in use.
Even if the battery is depleted, you can still deregister the handsets by 

following the steps above.

•

•