Utica Boilers SSV Hoja De Especificaciones

Combustion Air And Flue Vent Exhaust
9.1  The boiler shall allow for single pipe or direct vent installations.  The venting shall be constructed 

of approved materials and installed as per the manufactures written instructions, plan drawings 

and all applicable local code authorities.  Foam core pipe is not an approved vent material and 

Shall Not be used.  

9.2  The combustion air inlet and flue gas exhaust shall directly connect to the boiler at the locations 

labeled.  Boiler shall have the front removable jacket in place during operation.  The jacket can 

be taken off during commissioning and service per the manufactures written service and kit 

instructions

10.1 Boiler shall be equipped with a corrosion resistance polypropylene flue collector. An external drain 

trap shall be installed.  Flue collectors manufactured out of stainless steel or cast aluminum are 

not acceptable.  The drain line external to the boiler shall be constructed of approved materials 

and installed as per the manufactures written instructions, plan drawings and all applicable local 

code authorities.

11.1 Supply voltage 120 volts 60 HZ 12 amp minimum size circuit.  The boiler shall have terminals for 

a system pump and a domestic hot water pump.  The terminals for these pumps shall be rated 

for 120 volts with a 1 amp FLA connections on 100 mbh and smaller, 10 amp FLA on 150 mbh 

and larger.

11.2 The boiler shall have Line voltage and separate Low voltage terminal strips with clearly marked 

connections.

12.1 Warranty - The Boiler shall be supplied with a written manufactures 15 year limited warranty on 

the heat exchanger and 1 year on parts and controls supplied with the boiler.

12.2 Factory Testing – The boiler shall be factory fired tested and a combustion report generated and 

included with the boiler.  

13.1  The boiler shall be provided with a complete set of instructions and reports as follows:

Installation and Operation Manual (IOM) 

Repair Parts Manual

User’s Manual

Kit Instructions for field installed optional devices

P/N 240010731 REV B, [08/2014]