Proxim Tsunami MP.11 and MP.11a CPN 65755B Manual De Usuario

Proxim recommends you switch off the MP.11/a and the computer before connecting or disconnecting 
the serial RS-232C cable. 

To download an image file: 

1.  Set up the TFTP server as described in “TFTP Server Setup” 

  

2.  Start the terminal program (such as HyperTerminal), set the following connection properties, and 

then connect: 

COM port 

(for example COM1 or COM2, to which the MP.11 serial port is connected)

Bits per second 

9600 

Data bits 

8 

Stop bits 

1 

Flow control 

None 

Parity None 

 

3. 

Press the RESET button on the MP.11/a unit; the terminal program displays Power On Self Test 
(POST) messages.

 

4. 

When the

 

 

message is displayed after 

about 30

 

seconds, press the

 

 

key

. 

5. 

The command prompt is displayed; enter the following commands

: 

set ipaddr <IP address MP.11> 
set ipsubmask <subnet mask> 
set ipaddrtype static 
set tftpipaddr <IP address TFTP server> 
set tftpfilename <image file name> 
set ipgw <gateway IP address> 
reboot 

For example: 

set ipaddr 10.0.0.12 
set ipsubmask 255.255.255.0 
set ipaddrtype static 
set tftpipaddr 10.0.0.20 
set tftpfilename image.bin 
set ipgw 10.0.0.30 
reboot 

The MP.11/a reboots and downloads the image file.  The TFTP server program should show download 
activity after a few seconds.  When the download is complete, the MP.11/a is ready for configuration. 

To access the MP.11/a see “Chapter 3.  Management Overview” 

  Note that the IP 

configuration in normal operation differs from the IP configuration of the Boot Loader.