Proxim Tsunami MP.11 and MP.11a CPN 65755B Manual De Usuario

This chapter helps you to isolate and solve problems with your MP.11/a. In the event this chapter does 
not provide a solution, or the solution does not solve your problem, check our support website: 

Before you start troubleshooting, it is important that you have checked the details in the user’s guides 
and manuals. For details about RADIUS, TFTP, terminal and telnet programs, and Web browsers, 
please refer to their appropriate documentation. 

The following sections can help to solve your problem: 

▪ 

LED Indicators below 

▪ 

▪ 

In some cases, rebooting the MP.11/a clears the problem.  If nothing else helps, consider a “Soft Reset 
to Factory Defaults”  (

requires you to download a new image file to the MP.11/a. 

The following table shows the status of the four LEDs when the MP.11/a is operational (the 
fourth LED is unused). 

OFF 

No power is present or malfunctioning. 

GREEN 

Power is present; the unit is operational. 

AMBER 

The unit is initializing after reboot (less than two minutes); it cannot get a dynamic IP 
address or is in Forced Reload state when Ethernet LED also is amber.* 

RED 

A fatal error in the unit. 

OFF Not 

connected. 

GREEN 

Connected at 10 Mbps. 

BLINKING GREEN 

Data is being sent. 

AMBER 

Connected at 100 Mbps, in Forced Reload state when Power LED also is amber*, or 
the unit is initializing after reboot (less than two minutes). 

BLINKING AMBER 

Data is being sent. 

RED 

An error in data transfer. 

OFF 

Wireless interface is up properly but no wireless link established. 

GREEN 

Immediately after connecting a wireless link. 

BLINKING GREEN 

Data is being sent or the wireless interface is initializing after reboot (less 
than two minutes).

 

RED 

There is a fatal error on the wireless interface. 

* See “Forced Reload” on page 106.