Proxim Tsunami MP.11 and MP.11a CPN 65755B Manual De Usuario

The MP.11/a can be powered by a power supply or by Active Ethernet through an Active Ethernet 
splitter. Depending upon the powering method, you can switch the MP.11/a on by: 

▪ 

Plugging the power cord of the power supply into an AC power outlet 

▪ 

Connecting the Active Ethernet splitter to the Ethernet cabling 

When the power is switched on, the MP.11/a performs startup diagnostics.  When startup is completed, 
the LEDs show the operational state of the MP.11/a (see the following figure). 

 

The following table shows the status of the four LEDs when the MP.11/a is operational (the 
fourth LED is unused). 

OFF 

Power is not present or is malfunctioning. 

GREEN 

Power is present; the unit is operational. 

AMBER 

The unit is initializing after reboot (less than two minutes); it cannot get a dynamic IP 
address or is in Forced Reload state when Ethernet LED also is amber.* 

RED 

A fatal error in the unit. 

OFF Not 

connected. 

GREEN 

Connected at 10 Mbps. 

BLINKING GREEN 

Data is being sent. 

AMBER 

Connected at 100 Mbps, in Forced Reload state when Power LED also is amber*, or 
the unit is initializing after reboot (less than two minutes). 

BLINKING AMBER 

Data is being sent. 

RED 

An error in data transfer. 

OFF 

Wireless interface is up properly but no wireless link established. 

GREEN 

Immediately after connecting a wireless link. 

BLINKING GREEN 

Data is being sent or the wireless interface is initializing after reboot (less 
than two minutes).

 

RED 

There is a fatal error on the wireless interface. 

* See “Forced Reload” on page 106.