Proxim Tsunami MP.11 and MP.11a CPN 65755B Manual De Usuario

You can also use the CLI through the serial port of the MP.11/a with a terminal program such as 
HyperTerminal. You can use this method for cases in which other access methods cannot be used, or 
when the IP address of the MP.11/a cannot be set or retrieved.   Also see “Hard Reset to Factory 
Default”

To use the CLI through the serial port of the MP.11/a the following items are required: 

▪ 

A serial RS-232C cable with a male and a female DB-9 connector.  The serial cable must have a 
minimum of the following connections: 

Pin 2 ----------------Æ Pin 

2 

Pin 3 ----------------Æ Pin 

3 

Pin 5 ----------------Æ Pin 

5 

▪ 

An ASCII terminal program, such as HyperTerminal. 

Proxim recommends you switch off the MP.11/a and the computer before connecting or disconnecting 
the serial RS-232C cable. 

To access the MP.11/a through the serial port: 

1.  Start your terminal program. 

2.  Set the following connection properties; then connect: 

COM port              (For example, COM1 or COM2, to which the MP.11/a serial port is connected.) 
Bits per second    9600 
Data bits                8 
Stop bits                1 
Flow control          none 
Parity                    none 
Line ends              carriage return with line feed 

3. 

Press the RESET button on the MP.11/a unit.  The terminal program displays Power On Self Test 
(POST) messages.  After approximately 90 seconds it displays: 
Please enter password:

 

4.  Enter the password.  The default password is public. 

You can now use the CLI.