Proxim Tsunami MP.11 and MP.11a CPN 65755B Manual De Usuario
Tsunami MP.11and MP.11a Installation and Management
Appendix B. Troubleshooting
This chapter helps you to isolate and solve problems with your MP.11/a. In the event this chapter does
not provide a solution, or the solution does not solve your problem, check our support website:
not provide a solution, or the solution does not solve your problem, check our support website:
Before you start troubleshooting, it is important that you have checked the details in the user’s guides
and manuals. For details about RADIUS, TFTP, terminal and telnet programs, and Web browsers,
please refer to their appropriate documentation.
and manuals. For details about RADIUS, TFTP, terminal and telnet programs, and Web browsers,
please refer to their appropriate documentation.
The following sections can help to solve your problem:
▪
LED Indicators below
▪
▪
In some cases, rebooting the MP.11/a clears the problem. If nothing else helps, consider a “Soft Reset
to Factory Defaults” (
to Factory Defaults” (
requires you to download a new image file to the MP.11/a.
LED INDICATORS
The following table shows the status of the four LEDs when the MP.11/a is operational (the
fourth LED is unused).
fourth LED is unused).
Power
OFF
No power is present or malfunctioning.
GREEN
Power is present; the unit is operational.
AMBER
The unit is initializing after reboot (less than two minutes); it cannot get a dynamic IP
address or is in Forced Reload state when Ethernet LED also is amber.*
address or is in Forced Reload state when Ethernet LED also is amber.*
RED
A fatal error in the unit.
Ethernet Link
OFF Not
connected.
GREEN
Connected at 10 Mbps.
BLINKING GREEN
Data is being sent.
AMBER
Connected at 100 Mbps, in Forced Reload state when Power LED also is amber*, or
the unit is initializing after reboot (less than two minutes).
the unit is initializing after reboot (less than two minutes).
BLINKING AMBER
Data is being sent.
RED
An error in data transfer.
Wireless Link
OFF
Wireless interface is up properly but no wireless link established.
GREEN
Immediately after connecting a wireless link.
BLINKING GREEN
Data is being sent or the wireless interface is initializing after reboot (less
than two minutes).
than two minutes).
RED
There is a fatal error on the wireless interface.
* See “Forced Reload” on page 106.
Appendix B. Troubleshooting
111
CPN 65755B
Issue Date: August 2003