Lorex SG21FD3044-161 Manual De Usuario

 
 

 17  

h) 

DEFAULT SET : Selecting [Y] resets all programmed settings back to the default factory 
settings (except for the time & date). 

 If you perform a DEFAULT SET, the programmed data you have entered for the 

DDNS will be automatically deleted.  You need to set the data again. 

This sub-menu allows you to configure various preferences on the system, related to DVR 
settings. 

a) 

HDD INFO DISP : Sets the display settings for information on the HDD status. This can 
be displayed as a percentage of HDD space used, or amount of Bytes available, or the 
HDD information display can be set to OFF. 

b) 

RS232 BAUD RATE : Sets the speed at which the RS 232 input and the computer 
communicate.  Baud Rate, which is  the rate of data transmission, can be set to: OFF, 
2400, 4800, 9600, or 19200. 

c) 

PASSWORD SET : If you select [Y], you will need to input a password when you enter 
the Main Menu, and [N] will allow you into the menu without a password.  Changes your 
password for accessing the Menu. The password must be 4 digits. 

d) 

NETWORK (TCP/IP) : There are 3 selections to choose 

Dynamic IP: enabling this option will result in the unit automatically obtaining an IP 
address from the Router 

Static IP: Enabling this option will allow the user to set their IP address 

OFF: if this option is enabled, networking will be disabled. 

e) 

USER ID/PASSWORD : User can set password for Master ID and account.  Default 
value - ADMIN 

f) 

GUEST PASSWORD : User can set password for GUEST account. Default value – 
GUEST  

Master gets full accessibility in network whereas GUEST can view only 

g) BAND 

WIDTH 

h) 

IP ADDR : Set IP address for enabling network.  
Default value - 192 168 001 100  

 

NOTE: automatically set when Dynamic IP is enabled 

i) 

SUB NET : User can set Subnet Mask value for enabling network.  

Default value - 255 255 255 0 

 

NOTE: automatically set when Dynamic IP is enabled 

j) 

GATEWAY : Setting up Gateway value for enabling network.   
Default value - 192 168 001 001 

 

NOTE: automatically set when Dynamic IP is enabled 

k) 

PORT : Setting up Port value for enabling network.   
Default value - 5000 

This submenu allows you to set the Record parameters for your Hard Disk Drive.