Hitachi Flooring NT50AGF Manual De Usuario

— 17 —

Before using the model NT50AGF Pneumatic Flooring Nailer, a 3/8” 

Thread Fitting must be installed.  The NT50AGF Pneumatic Flooring 

Nailer has an adapter installed to accept a 3/8” Thread fitting.  This 

provides the owner the advantage of installing the preferred Fitting 

of choice. (ie: Hitachi Fittings; Industrial (P/N 190051), Automotive 

(P/N 190071)). This allows the freedom to use any configuration of 

quick connect fitting with either a 3/8 NPT thread or a combination 

of a 1/4 NPT thread fitting and 3/8 – 1/4 NPT reducer.  Install the Fit-

ting into the supplied adapter and gently tighten.

CAUTION: Do not remove the installed adapter.  This adaptor pro-

vides connection of the Fitting of choice as well as protecting the 

integrity of the NT50AGF Pneumatic Flooring Nailer Body from inlet 

port damage.

IMPORTANT: The 

bottom hole of the 

NT50AGF that is 

plugged should 

NEVER be removed.   

If plug is removed,  

the NT50AGF Pneu-

matic Flooring Nailer 

will not perform cor-

rectly and serious 

damage may occur.

Loosen or remove Flange Nuts (Ref. No. 33) with Wrench and 

unscrew the Shoe Screw (Ref. No. 50) to remove and change over 

from Tongue Nailing to Face Nailing Applications. Change from 

Face Nailing to Tongue Nailing by loosening or removing Flange 

Nuts (Ref. No. 33) with Wrench and Face Shoe Screw (Ref. No. 42).  

Always tighten the Shoe Screw (Ref. No. 50 or 42) before tightening 

the Flange Nuts (Ref. No. 33).

33

50

33

42