Extron electronic Multi-Graphic Processor MGP 464 Manual De Usuario

Operation, cont’d

MGP 464 • Operation

3-18

PRELIMINAR

Making changes to the serial port and IP configuration

To make changes to the serial port configuration, IP address, DHCP mode, Gateway

address, and/or Subnet mask, you must access the edit level screens as follows:

With any Comm./IP Configuration menu view-level screen displayed,

press the Enter button and hold it until the Serial Config screen appears

(approximately 2 seconds).

Press Next repeatedly to cycle through the edit level screens.

To enter or change information on each screen, rotate the horizontal Adjust

knob (

[

) to move the angle brackets to the desired setting. Rotate the

vertical Adjust knob (

{

) to adjust the setting.

When finished editing the settings for the selected item, either press Next to

go to the editing screen for the next item, or press Menu to exit serial/IP edit

mode and go to the next menu (Advanced Configuration).

Screens are provided for editing the following parameters:

•

Serial Config:

Configure the serial port by switching between RS-232 and

RS-422, and selecting the baud rate.

•

Set DHCP Mode:

Set DHCP to On or Off.

DHCP must be off before you can edit the IP addresses.

•

Set IP Address:

Set the IP address.

•

Set Gateway Addr:

Set the gateway address.

•

Set Subnet Mask:

Set the subnet mask.

You cannot edit the MAC address; there is no editing screen for it.

Background Capture

Comm. / IP

Configuration

Serial Port

RS232 9600

IP Address

010.013.005.130

Set DHCP Mode

<Off>

Rotate either Adjust knob
to adjust the submenus.

Press and
hold the
Enter button
for 2 seconds.

DHCP Mode

Off

Serial Config

<RS232> 9600

MAC Address

0005A600C1A5

Gateway Address

010.013.000.100

Set Gateway Addr

<010>.013.000.100

Subnet Mask

255.255.000.000

Set IP Address

<010>.013.005.130

Set Subnet Mask

<255>.255.000.000

View level

Edit level

Advanced

Configuration

Communication/IP Configuration menu flow