Extron electronic Multi-Graphic Processor MGP 464 Manual De Usuario

To change the name of an input,

. 

On the Scaler I/O Settings screen, select and delete the text in the box under 

the desired input number.

. 

Enter a name of up to 16 characters for the input.  The following characters 

may be used:

 

  :  /  –  _  +  “

 

  0 through 9

 

 Lowercase a through z, uppercase A through Z

 

 also can be used.

Under each input name box is a pull-down menu from which you can select the 

video signal type for the input.

 — RGB, YUV-HD, RGBcvS, and DVI (MGP 464 DI 

only) are available on inputs 1 through 4 only.  YUVi 

component video, S-video, and composite video are 

available on all inputs.

 

The virtual inputs (5 through 19) are displayed on the 

screen in groups of three, with one drop-down menu for 

each set of three inputs.  

 

For each virtual input group, 
•  If you select YUVi from the menu, all three 

inputs in the group are configured together 

as one component video input.  

•  If you select S-Video,Comp, the first (top) two 

inputs are configured as S-video and the 

third, as composite.  

•  If you select Comp,Comp,Comp, each input in 

the group is configured as composite video. 

 — To place an input in film mode, which enables 3:2 and 2:2 pulldown, 

select the Film Mode check box below or to the right of the signal type menu.  

If RGB, YUV-HD, or DVI is selected as the signal type, this check box is 

unavailable.     

In the Output Configuration section of the Scaler I/O Settings screen, you can select 

output parameters from the following pull-down menus:

 — Select the resolution at which the image is displayed on the output 

screen.

 — Select the rate in Hz at which the output screen is refreshed.

 — Select the output signal type required by the display device.  

Available formats are RGBHV, RGBS, RGsB, YUV bi-level and YUV tri-level.

 — Select the combination of horizontal and vertical synchronization signal 

polarities.