Gateway E-9520T Manual De Usuario
www.gateway.com
49
Replacing the system board
To replace the system board:
1
Follow the instructions in
. Make sure
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
to the server.
2
Follow the instructions in
.
3
Set the server on its side to make it easier to work on.
4
Remove the PCI expansion cards by following the instructions in
.
5
6
7
Disconnect all cables from the system board, noting their locations and orientation. (You
will reconnect the cables after you install the new board.)
will reconnect the cables after you install the new board.)
8
Loosen the two thumbscrews (2) that secure the system board to the server.
9
Slide the system board toward the front of the server until it is free of the six retaining
standoffs (1), then lift the board from the chassis.
standoffs (1), then lift the board from the chassis.
10
Place the old system board in a static-free bag for storage.
2
1
1
1
1
1