ELAN Home Systems Digital Music Server Manual De Usuario

E L A N   H O M E   S Y S T E M S  

© ELAN Home Systems  2004 • All rights reserved.  02/04

Page 11

USER GUIDE

The TV and Amp devices on the VIA!dj remote control may be
individually configured to control a range of televisions and
amplifiers from well known manufacturers.  

•

Press the 

and

buttons simultaneously; hold them

down for 1 second.  

The 

button will remain lit for 20 seconds; the configu-

ration process must be completed during this time.

•

Enter the 3 digit numeric code matching the manufacturer
of your television from the list in 

•

Press the 

button again.

The 

button will blink twice to indicate that the configuration

has been accepted.  If the 

button does not blink begin the

process again, taking care to enter the number exactly as print-
ed in the list.  If the television is switched on during the config-
uration process, entering the correct code will cause the televi-
sion to go into standby.

•

Press the 

and 

buttons simultaneously; hold

them down for 1 second.  

The 

button will remain lit for 20 seconds; the 

configuration process must be completed during this time. 

•

Enter the 3 digit numeric code matching the manufacturer
of your amplifier from the list in Appendix A.

•

Press the 

button again.

The 

button will blink twice to indicate that the configura-

tion has been accepted.  If the 

button does not blink

begin the process again, taking care to enter the number
exactly as printed in the list.  If the amplifier is switched on 
during the configuration process, entering the correct code will
cause the amplifier to go into standby.

The VIA!dj was designed to remain on 24/7/365. If the VIA!dj is
not going to be used for an extended period of time and you
wish to turn it off, there are two power saving modes available
from the Standby button on the VIA!dj front panel and the 
button on the remote control. The VIA! Touch Panel can be
used to take the VIA!dj out of Standby, but it cannot be used to
put the VIA!dj into Standby Mode.

Putting the unit into 

takes just a few seconds; switch-

ing the unit on from 

also takes just a few seconds.  

remove the power cord from the VIA!dj in this mode.

should be used only if the VIA!dj is not being used

for an extended period of time.  There is a short wait while the
unit is switched to off mode; switching the unit on from off
mode may take a few minutes.  You can safely remove the
power from the VIA!dj in this mode.

•

Press the 

key on the front panel or the 

key on the remote control. 

The following screen is displayed:

The front panel display shows:

•

Press the 

button on any VIA! Touch Panel, or

the 

action key on the front panel, or the 

key on

the remote control to switch to standby.

After a short delay the screen shows:

•

Press the 

button on any VIA! Touch Panel, or the 

action key on the front panel, or the 

key on the

remote control to switch to off mode.

After a short period of time the display and front panel display
will switch off.

•

Press the 

button on any VIA! Touch Panel, or

press the 

key on the front panel, or the 

key on the remote control.