Brother XL-2610i Manual De Usuario
39
5
Appliqués
You can create an applique by cutting a different
piece of fabric into a shape and using it as a
decoration.
piece of fabric into a shape and using it as a
decoration.
1
Baste the cut design to the fabric.
2
Carefully sew around the edge of the design
with a zigzag stitch.
with a zigzag stitch.
3
Cut away any fabric that is left outside the
stitching.
stitching.
4
Remove the basting, if necessary.
Memo
● Make reinforcing straight stitches at the
beginning and the end of the zigzag
stitching.
stitching.
Monogramming and
Embroidering
Embroidering
■ Preparing for Monogramming and Embroidering
1
Turn off the machine.
Place the darning plate on the needle plate,
then turn on the machine.
Place the darning plate on the needle plate,
then turn on the machine.
2
Set the pattern selection dial to Zigzag Stitch.
3
Draw the lettering (for monogramming) or
design (for embroidering) on the surface of
the fabric.
design (for embroidering) on the surface of
the fabric.
4
Stretch the fabric between embroidery hoops
as firmly as possible, with the underside of the
fabric on the bottom of the inside hoop.
as firmly as possible, with the underside of the
fabric on the bottom of the inside hoop.
5
Put the work under the needle and lower the
presser bar with the foot removed.
presser bar with the foot removed.
6
Pull the lower thread up through the starting
position by turning the handwheel and make a
few holding stitches.
position by turning the handwheel and make a
few holding stitches.
Stitch Name Pattern
Stitch Length
[mm (inch)]
Stitch Width
[mm (inch)]
Zigzag Stitch
F-2
(1/64-1/16)
Any
●
Be careful that the needle does not hit a
pin during sewing. The needle could
break, and you may be injured.
pin during sewing. The needle could
break, and you may be injured.
CAUTION
Stitch
Name
Pattern
Stitch
Length
[mm
(inch)]
Stitch
Width
[mm
(inch)]
Foot
Other
Zigzag
Stitch
Any
Any
None Darning
Plate