Braun Activator 8595 Guía Del Usuario

 

5

 

1. Low-voltage adapter
2. «start cleaning» button 
3. Station-to-shaver connecting contacts
4. Station lift button for cartridge exchange
5. Display for cleaning programs
6. Display for cleaning fluid status
7. Station mains socket
8. Cleaning cartridge
9. Shaver foil protection cap

10. Shaver foil
11. Cutter block
12. Foil release buttons 
13. Long hair trimmer
14. Shaver-to-station connecting contacts 

(shaver backside)

15. Switch
16. Shaver display
17. Info key
18. Pilot light
19. Shaver mains socket 

 

If you wish, you may start shaving right away (if the shaver 
is charged, see section «Shaver display»). However, we 
recommend to follow the procedure described here:

• Using the low-voltage adapter (1), connect the mains 

socket of the Clean&Charge station (7) to the mains. 

• Press the station lift button (4) to open the housing.

• Hold the cleaning cartridge (8) down on a flat, stable 

surface (e.g. table). 

• Carefully remove the lid from the cartridge. 

• Slide the cartridge into the base of the station as far as 

it will go.

• Slowly close the housing by pushing it down until it 

locks.

2

1

 

5643451_S4_102  Seite 5  Montag, 8. September 2003  11:48 11