Sony ICF-DVD57TV Manual De Usuario
26
Notes
• When “OFF” is selected, no signal is output from
• When “OFF” is selected, no signal is output from
the OPTICAL OUTPUT connector.
• When you connect the player and a digital
recording device such as an MD player through
an optical cable to record the CD contents with
that device, the contents will be recorded as one
continuous track.
an optical cable to record the CD contents with
that device, the contents will be recorded as one
continuous track.
• If noise occurs in peripheral equipment when
using DIGITAL OUTPUT, select “OFF” to turn off
DIGITAL OUTPUT.
DIGITAL OUTPUT.
• Sampling sound of 96kHz is changed to 48kHz.
• If the sound setting is changed to DTS by the
• If the sound setting is changed to DTS by the
AUDIO button or Disc menu, no sound is emitted
from the speaker.
from the speaker.
• When you connect to another unit which does
not support the DTS function and change the
sound setting to DTS, noise may occur. In this
case, change the audio setting to other than DTS.
sound setting to DTS, noise may occur. In this
case, change the audio setting to other than DTS.
• While the playing back a CD, whether the
DIGITAL OUTPUT is set to RAW or PCM, there is
no difference in the audio effect.
no difference in the audio effect.
♦
DRC (Dynamic Range Control)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to “Audio DRC“. You can set the
DRC level from 9 steps (including “OFF“). This
setting affects the outputs of OPTICAL
OUTPUT.
turned down when playing a DVD that
conforms to “Audio DRC“. You can set the
DRC level from 9 steps (including “OFF“). This
setting affects the outputs of OPTICAL
OUTPUT.
MAX: Makes the low sounds clear even if you turn
the volume down.
OFF: Set to enjoy the dynamic sound.
Settings for digital audio
output
output
— AUDIO SETUP
A U D I O S E T U P
D O W N M I X
D I G I T A L O U T P U T
D R C
S E L E C T :
< , , E N T E R Q U I T : S E T U P
♦
DOWNMIX
You can select the downmix mode from
“Surround” or “Normal”. The downmix
function is used to create stereo (2-channel)
signals from more than 5 separated digital
signals of a source. This setting affects the
outputs of OPTICAL OUTPUT.
“Surround” or “Normal”. The downmix
function is used to create stereo (2-channel)
signals from more than 5 separated digital
signals of a source. This setting affects the
outputs of OPTICAL OUTPUT.
SURROUND Normally, select this position.
Multi-channel audio signals are
output to 2 channels for enjoying
surround sounds.
output to 2 channels for enjoying
surround sounds.
NORMAL
Multi-channel audio signals are
downmixed to 2 channels for use
with your stereo.
downmixed to 2 channels for use
with your stereo.
♦
DIGITAL OUTPUT
You can set the mode of the audio signals
output from the OPTICAL OUTPUT
connector.
output from the OPTICAL OUTPUT
connector.
RAW
Select this when you connect an
audio component with a built in
Dolby Digital decoder or DTS
decoder.
audio component with a built in
Dolby Digital decoder or DTS
decoder.
PCM
Select this when you connect an
audio component without a
built-in Dolby Digital decoder or
DTS decoder. The downmix signal
is output.
audio component without a
built-in Dolby Digital decoder or
DTS decoder. The downmix signal
is output.
OFF
No signal is output from OPTICAL
OUTPUT connector.
OUTPUT connector.