Harbor Freight Tools 1_1/8 in. 10 Amp Heavy Duty SDS Variable Speed Rotary Hammer Manual Del Producto
Page 10
For technical questions, please call 1-888-866-5797.
Item 61882
SAFET
y
Op
ERA
TION
ERA
TION
M
AINTENAN
c
E
SETU
p
p
Adjusting the Functions
Adjust the Drill Switch and Hammer Switch before using
the Rotary Hammer. To adjust the Drill Switch, rotate the
Switch until it clicks in place at one of the two positions.
Drill ON
Drill OFF
Figure D: Drill Switch
To adjust the Hammer Switch, rotate the Switch until it is
horizontal, pointed toward the right or left side of the tool.
Hammer
OFF
Hammer
ON
Figure E: Hammer Switch
cAUTION: Move the Switches only when the
Motor is stopped. Attempting to move the Switches
while the Motor is engaged will result in abrupt
bit rotation and can cause property damage.
cAUTION: When moving the Switches, make sure they
click into the desired position. If not actively engaged, a
Switch could slip out of position resulting in tool damage.
To Drill: Rotate the Drill Switch to the Drill ON setting.
Rotate the Hammer Switch to the Hammer OFF Setting.
The Rotary Hammer will revolve when powered.
To Hammer/Drill: Rotate the Drill Switch to the
Drill ON setting. Rotate the Hammer Switch to
the Hammer ON setting. The Rotary Hammer
will revolve and hammer when powered.
To chisel: Rotate the Drill Switch to the Drill OFF
setting. Rotate the Hammer Switch to the Hammer ON
setting. The Rotary Hammer will hammer when powered.
Work piece and Work Area Set Up
1. Designate a work area that is clean and well-
lit. The work area must not allow access by
children or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
1. Install the Drill Bit.
2. Adjust the Auxiliary Handle and the
Depth Gauge as needed.
3. Set the Function by adjusting the Drill Switch
and Hammer Switch to the desired setting.
4. Set the speed by rotating the Speed Control.
5. Plug in the Power Cord.
6. Squeeze and hold the Trigger to
turn on the Rotary Hammer.
7. Allow the Rotary Hammer to reach full speed
before contacting the work surface.
8. When finished, to prevent accidents, turn off the tool
and disconnect its power supply after use. Allow
the bit to cool then remove it from the Chuck. Clean,
then store the tool indoors out of children’s reach.