Harbor Freight Tools 15 Amp Heavy Duty Professional Breaker Hammer Manual Del Producto
Page 10
For technical questions, please call 1-888-866-5797.
Item 68147
SAFET
y
Op
ERA
TION
ERA
TION
M
AINTENAN
c
E
SETU
p
p
Operating instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Chisels come with or without collars. Figure C
Chisels come with or without collars. Figure C
shows installation of a chisel without a collar
(the included chisel is without a collar). Figure G
shows installation of a chisel with a collar.
Note: If the Chisel doesn’t slide in easily, apply
grease to the loading end of the Chisel.
Mounting chisels without a collar
1. Pull the Lock Lever to the side, just
far enough to allow the Chisel to be
inserted, as shown in Figure C.
Flat
Notch
1
2
Lock
Lever
Figure c
Note: Flat Notch on Collar-less Chisel
must face the Lock Lever.
2. Insert Chisel with the Flat Notch facing the
Lock Lever, as shown in Figure D.
Lock Lever
Figure D
3. Slide the Chisel in as far as it will go.
4. Pull the Lock Lever back until it locks the
Chisel into place. See Figure E.
Note: Lock Lever will not lie flat against the chuck.
Flat Notch
play
Figure E
5. When the Chisel is installed, there will be
approximately 1-3/4" of play along the Flat Notch
of the shank. See Figure E. Physically check
that the Chisel is secure before operating.