Brother NV6000D Manual De Usuario
SEWING THE STITCHES
U
tili
ty Stit
ty Stit
ch
es
es
97
3
e
Position the side cutter so that the side
cutter pin is aligned with the notch in the
presser foot holder, and then lower the
presser foot.
cutter pin is aligned with the notch in the
presser foot holder, and then lower the
presser foot.
a Notch in presser foot holder
b Pin
o The side cutter is attached.
b Pin
o The side cutter is attached.
f
Raise the presser foot and pull out a long
section of the upper thread. Pass it below
the presser foot and pull it out in the fabric
feed direction.
section of the upper thread. Pass it below
the presser foot and pull it out in the fabric
feed direction.
a Presser foot
b Upper thread
b Upper thread
g
Make a cut of approximately 20 mm
(approx. 3/4 inch) in the fabric.
(approx. 3/4 inch) in the fabric.
a 20 mm (approx. 3/4 inch)
h
Position the fabric so that the right side of
the cut is on top of the guide plate and the
left side of the cut is underneath the presser
foot.
the cut is on top of the guide plate and the
left side of the cut is underneath the presser
foot.
a Guide plate (lower knife)
b Presser foot
c Upper thread
b Presser foot
c Upper thread
Memo
• If the fabric is not positioned correctly, the
fabric will not be cut.