Harbor Freight Tools 3 Ton Steel Jack Stands Manual Del Producto
Page 2
For technical questions, please call 1-800-444-3353.
Item 61196/61197
Specifications
Item
61196
61197
Capacity
3 Tons (6,000 lb.)* 6 Tons (12,000 lb.)*
Approximate Height Range
11-3/4" – 16-3/4"
14-1/2" – 23-3/4"
*Evenly distributed across two Jack Stands.
Both Jack Stands meet 2005 ANSI/ASME PALD standards.
Important Safety Information
Failure to heed these markings may result in
personal injury and/or property damage:
1.
Study, understand, and
follow all instructions before
operating this device.
2.
Do not exceed rated capacity.
3.
Use only on hard, level surfaces.
4.
Center load on saddle.
5.
Use as matched pair to support
one end of a vehicle only.
6.
Wear ANSI-approved safety goggles
and heavy-duty work gloves
during use.
7.
Do not use for aircraft purposes.
8.
Support vehicle only at manufacturer-
recommended locations.
9.
Inspect before every use;
do not use if parts loose or damaged.
Do not use if even a minor crack,
bend or other damage/deformation
appears. Discard Jack Stand
if damaged or deformed.
10.
Keep work area clean.
Cluttered areas invite injuries.
11.
Observe work area conditions.
Keep work area well lighted.
12.
Keep children away. Children must
never be allowed in the work area.
13.
Stay alert. Watch what you are doing,
use common sense. Do not operate
any tool when you are tired.
14. The warnings, cautions, and instructions
discussed in this instruction manual
cannot cover all possible conditions
and situations that may occur. It must
be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.