Siemens 1015N-2MFM-1A Manual De Usuario

1015N-2MFM-1A

CAUTION: Do not connect a serial data cable to J1 on the 1015N-2M Modem Card or

damage to the Modem Card and flowmeter may result.

4. Loosen the four captive screws (1) at the corners of the 1010N-2 module (7) and carefully

lift out the module disengaging it from the connector on the 1010N-5 module (2).

5. Lift off the shield (3) covering the 1010N-5 module (2).

6. Leave the 1010N-5 module in place. Check to assure that the four corner standoffs (4) are

securely threaded in place.

ASSEMBLY (see Figure 3)

7. Install shield (5) supplied with the 1015N-2M-MK1 mounting kit and cover the 1010N-5

module. Note: This shield replaces the shield removed in Step 5 above.

8. Remove the four captive screws (1) from the 1010N-2 module loosened in Step 4 above.

Install standoffs (6) from mounting kit in the vacant positions.

9. Install the 1010N-2 module (7) carefully engaging connector P1 to the 1010N-5 module (2).

Secure by threading the four standoffs (6) installed in Step 5 above with their mates on
the 1010N-5 module.

10. Check for properly alignment of P1.

Figure 3. Option 1 Installation (side view)

(11) 1010N-2 I/O
Module Cover

(9) 1010N-2 I/O Module

(12) Captive Screw

(1) 1010N-2 Captive Screws

(3) 1010N-5 Analog Module Shield

(4) Threaded Standoffs

(2) 1010N-5 Analog Module Assy

START VIEW

(11) 1010N-2 I/O

Module Cover

(9) 1015N-2M

Modem Card

(7) 1010N-2

I/O Module

(12) Captive Screw

(10) Cover Mount

Standooff

(4) Threaded Standoffs

(6) Threaded Standoff

(5) 1010N-5 Analog

Module Shield

(2) 1010N-5 Analog Module Assy

FINISH VIEW

Serial Data Cable - Not
used with 1015N-2M
Modem Card.