Rigid Industries Automatic Pipe and Bolt Threading Machine 535-A Manual De Usuario

1. Locate a work area that has the following:

• Adequate lighting.

• No flammable liquids, vapors or dust that may ignite.

• Grounded 20 AMP electrical outlet.

• Clear path to the electrical outlet that does not

contain any sources of heat or oil, sharp edges or
moving parts that may damage electrical cord.

• Dry place for machine and operator. Do not use

the machine while standing in water.

• Level ground.

2. Clean up the work area prior to setting up any equip-

ment. Always wipe up any oil that may have splashed
or dripped from the machine to prevent slips and falls.

3. If the workpiece extends more than four (4) feet beyond

the Threading Machine, use one or more pipe stands
to prevent tipping and the oscillation of the pipe.

4. If the workpiece extends beyond the Threading

Machine, set-up guards or barricades to create a min-
imum of three (3) feet of clearance around the
Threading Machine and workpiece. This “safety zone”
prevents others from accidentally contacting the
machine or workpiece and either causing the equip-
ment to tip or becoming entangled in the rotating parts.

5. If necessary, fill the reservoir with RIDGID Thread

Cutting Oil.

6. Make sure FOR/OFF/REV switch is in the OFF position.

7. Position the foot switch so that the operator can

safely control the machine, tools and workpiece. It
should allow the operator to do the following:

• Stand facing the control switch.

• Use the foot switch with his left foot.

• Have convenient access to the control switch and

tools without reaching across the machine.

Machine is designed for one person operation.

7

pin or if the cord is damaged, do not use the
Threading Machine until the cord has been replaced.

6. Inspect the Threading Machine for any broken, miss-

ing, misaligned or binding parts as well as any other
conditions which may affect the safe and normal
operation of the machine. If any of these conditions
are present, do not use the Threading Machine until
any problem has been repaired.

7. Lubricate the Threading Machine if necessary accord-

ing to the Maintenance Instructions.

8. Use tools and accessories that are designed for your

Threading Machine and meet the needs of your
application. The correct tools and accessories allow
you to do the job successfully and safely. Accessories
designed for use with other equipment may be haz-
ardous when used with this Threading Machine.

9. Clean any oil, grease or dirt from all handles and

controls. This reduces the risk of injury due to a tool or
control slipping from your grip.

Inspect the cutting edges of your tools and dies. If
necessary, have them replaced prior to using the
Threading Machine. Dull or damaged cutting tools and
dies can lead to binding, tool breakage and poor
quality threads.

NOTE! High speed dies are recommended for use with

this machine. Because of its high speed, alloy
dies will wear quickly and produce poor quality
threads.

10. Clean metal shavings and other debris from the chip

tray of the Threading Machine. Check the level and
quality of the thread cutting oil. Replace or add oil if
necessary. Reservoir in the base will hold approxi-
mately seven (7) quarts of thread cutting oil.

NOTE! Thread cutting oil lubricates and cools the threads

during the threading operation. A dirty or poor
grade cutting oil can result in poor thread quality.

NOTE! For quality threads use RIDGID Stainless Steel

Oil when threading at 58 RPM.

NOTE! To drain dirty oil and properly maintain the oil

system, refer to the “Maintenance Instructions”.