PASCO Specialty & Mfg. Photogate Brackets ME-9806 Prospecto
I n s tr u c t i o n S he e t
0 1 2 - 1 0 2 7 8 A
800-772-8700
www.pasco.com
®
Photogate Brackets
ME-9806
The Photogate Brackets set
includes parts for mounting
two photogates on a PASCO
dynamics track. The brackets
attach to the T-slots on the
sides of a dynamics track.
includes parts for mounting
two photogates on a PASCO
dynamics track. The brackets
attach to the T-slots on the
sides of a dynamics track.
1.
Loosen (but do not
remove) the square nut on
the thumbscrew.
remove) the square nut on
the thumbscrew.
2.
Slide the nut into the
T-slot at the end of the
track.
T-slot at the end of the
track.
3.
Slide the bracket along the track to the desired location.
4.
Tighten the thumbscrew to
secure the bracket.
secure the bracket.
5.
Remove the rod-mounting
clamp from a photogate.
clamp from a photogate.
6.
Insert a small thumbscrew through the upper slot of the
bracket and into the mounting hole in the photogate.
bracket and into the mounting hole in the photogate.
Note: Use the shorter thumbscrew (3/8 inch, 10 mm) included with the
brackets, not the longer screw that came with the photogate.
brackets, not the longer screw that came with the photogate.
7.
Adjust the height of the photogate.
8.
Tighten the thumbscrew to secure the photogate.
Technical Support
For assistance with any PASCO product, contact PASCO at:
Limited Warranty
For a description of the product warranty, see the
PASCO catalog.
Copyright
The PASCO scientific 012-10278A
Photo-
gate Brackets Instruction Sheet
is copyrighted with all rights reserved.
Permission is granted to non-profit educational institutions for reproduction
of any part of this manual, providing the reproductions are used only in
their laboratories and classrooms, and are not sold for profit. Reproduction
under any other circumstances, without the written consent of PASCO sci-
entific, is prohibited.
of any part of this manual, providing the reproductions are used only in
their laboratories and classrooms, and are not sold for profit. Reproduction
under any other circumstances, without the written consent of PASCO sci-
entific, is prohibited.
Trademarks
PASCO and PASCO scientific are
trademarks or registered trademarks of PASCO scientific, in the United
States and/or in other countries. For more information visit
www.pasco.com/legal.
States and/or in other countries. For more information visit
www.pasco.com/legal.
1
2
4
3
Included Equipment
Replacement Parts
1. Brackets (2 pieces)
ME-9806 (complete set)
2. Square Nuts (2 pieces)
ME-9823 (IDS Spares Kit)
3. Large Thumbscrews,
1/4-20 × 9/16 (2 pieces)
4. Small Thumbscrews,
6-32 × 3/8, (2 pieces)
Address: PASCO scientific
10101 Foothills Blvd.
Roseville, CA 95747-7100
Roseville, CA 95747-7100
Phone:
916-786-3800 (worldwide)
800-772-8700 (U.S.)
800-772-8700 (U.S.)
Fax:
(916) 786-7565
Web:
www.pasco.com
Email:
support@pasco.com