Panasonic Arbitrator 360 Guía Del Usuario

OPERATION

- Switch the power ON

(located on the bottom of TX unit)

- Prior to use, charge the unit by placing TX set in the

RX set at least for 3 hours

- Place TX on RX to sync the code

1. Charging mode

- While TX is placed in RX (No LED on), charging the battery

2. TALK mode

- While TX is displaced from Rx, TX TALK button will be standard

mode on automatically in 3 seconds
(LED blinking 2 times and then LED off ).
RX “TALK ON” LED will not be on since it’s not recording.

- While press TALK button on TX to trigger recording, TALK button

turns blue LED on. RX “TALK ON” LED will light up and
steady green

* When TX is out of range, Blue talk button will be changed by mode,

“ LED off / Beep > LED off / Vibration > LED off / Beep+Vibration

> LED off / None “

* While TX comes back in range, blue LED will be back on (steady).

* When the battery in low, blue talk button will be changed by mode

“LED blink fast > LED off > LED blink fast > LED off “

3. Warning MODE: MODE Selection button.

When a user pushes this button, the mode is changing in order.

“ Beep Tone > Vibration > Beep and Vibration > None “

4. “M” : Mute Button

When this button is pushed, audio data is not output during “Talk
On” mode. Talk button will be changed with next mode order.
“ LED blink slow >  LED off > LED blink slow >  LED off “

OPERATION

- Install the bracket by using the screws
- Slide RX Set onto the Bracket
- Connect the main cable to RX Set
- Connect the antenna (Internal Antenna or External Antenna

to the RX Set.

* Place external antenna on the windshield at the point (Horizontal

or Vertical) as following picture.

- Put the battery pack into TX Set

< External Antenna Installation >