Nortel Networks 13.03 Manual De Usuario
BayRS Version 13.03 and Site Manager Software Version 7.03 Release Notes
305279-C Rev 00
1-11
CR 106129: ATM
The router incorrectly determines specific 802.5 MAC addresses as broadcasts
when processing LE_ARP responses. This causes the LEC to restart.
when processing LE_ARP responses. This causes the LEC to restart.
CR 107143: ATM
The router is not responding to LE_ARP destined for it's own MAC address on
802.5 elans. This condition affects performance because the router sends
unnecessary traffic to other LECs and creates congestion on the bus.
802.5 elans. This condition affects performance because the router sends
unnecessary traffic to other LECs and creates congestion on the bus.
CR 107164: Frame relay
Bus errors occur on the FRE processor before it goes into diag mode when you
bring down a frame relay interface with an HSSI card configured with IP. This
occurs whenever the router brings down the frame relay interface after not
receiving the LMI status messages.
bring down a frame relay interface with an HSSI card configured with IP. This
occurs whenever the router brings down the frame relay interface after not
receiving the LMI status messages.
CR 107581: BGP
BGP is not advertising and withdrawing correctly when handling two
announcements of the same network to two different peers.
announcements of the same network to two different peers.
CR 107675: DVMRP
When a non-dominant router becomes the dominant router and subordinate
routers are contained in its loop neighbor list, the newly dominant router will not
graft traffic.
routers are contained in its loop neighbor list, the newly dominant router will not
graft traffic.
CR 107703: IGMP
Multicast data packets gets duplicated on a DVMRP router where MTM has
outbound cache entry on an inbound circuit.
outbound cache entry on an inbound circuit.
CR 107811: ATM
A memory leak occurs on the ATM interface after a virtual circuit is repeatedly
brought up and then killed using the Technician Interface.
brought up and then killed using the Technician Interface.
CR 107938: ATM
The router does not clean up the ATM circuit when a port is dynamically deleted
using Site Manager.
using Site Manager.