Craftsman 486.243201 Manual De Usuario

FIGURE 5

STEP 4: (SEE FIGURE 4)

• Assemble the hitch bracket to the front tongue using

two 3/8" x 1" hex bolts (B) and 3/8" hex nylock nuts
(L).

Tighten.

• Assemble the leg stand bracket to the front tongue

using two 5/16" x 1" hex bolts (C) and 5/16" nylock
nuts (K).

Tighten.

FIGURE 3

STEP 2: (SEE FIGURE 2)

• Assemble the latch lock subassembly to the rear

tongue using two 1/4" x 1" hex bolts (E) and 1/4"
nylock nuts (J).

Tighten.

• Assemble the plastic cap (O) to the front end of the

rear tongue.

STEP 3: (SEE FIGURE 3)

• Lay the rear tongue (open side facing up) onto the

Wheel Support. Assemble the axle through the wheel
support and the second hole from the end of the
tongue.

FIGURE 2

FRONT
TONGUE

(B) 3/8" x 1"
HEX BOLT

(L) 3/8" NYLOCK NUT

HITCH
BRACKET

LEG STAND
BRACKET

(K) 5/16" NYLOCK NUT

FIGURE 4

STEP 5: (SEE FIGURE 5)

• Place the front tongue inside the rear tongue as

shown in ﬁ gure 5. Fasten the tongues together using
a 3/8" x 4" hex bolt (A) and a 3/8" nylock nut (L).
Tighten, leaving the nut just loose enough that the
tongues can pivot freely.

• Insert the 3/8" x 4" clevis pin (G) through the tongues

and secure with a 1/8" hairpin cotter (M).

LATCH LOCK
SUB-ASSEMBLY

(E) 1/4" x 1"
HEX BOLT

(J) 1/4" NYLOCK NUT

REAR
TONGUE

(O) PLASTIC CAP

WHEEL
SUPPORT

REAR
TONGUE

AXLE

FRONT
TONGUE

(L) 3/8"
NYLOCK NUT

(A) 3/8" x 4"
HEX BOLT

(G) 3/8" x 4"
CLEVIS PIN

(M) 1/8" HAIRPIN
COTTER