Country Home Products DR TRIMMER/MOWERTM BEAVER BLADE Manual De Usuario

CALL TOLL FREE 1-800-DR-OWNER

CHAPTER 3

INSTALLING YOUR DR

TRIMMER/MOWER™ BEAVER BLADE

This chapter outlines a few simple steps you will need to follow to set up your new DR
TRIMMER/MOWER BEAVER BLADE before you use it. It may be helpful to familiarize yourself with the
parts of your DR TRIMMER/MOWER BEAVER BLADE assembly by reviewing Figure 1 before beginning
the steps outlined in this chapter.

Installation

Note: When using the aluminum Mow-Ball™ Support (recommended), you will NOT need to use the
rectangular washer because one is built in.

Tools Needed

•  Long Phillips head screwdriver
•  Gloves
•  DR

TRIMMER/MOWER™ Safety & Operating Instructions for reference.

1. Follow the steps in your DR

TRIMMER/MOWER™ Safety & Operating Instructions to remove the

trimmer head assembly from the bearing housing assembly. Remove the flanged bolt or the
standard bolt and rectangular washer insert completely (and store for future use), as they will not be
required when using the aluminum Mow-Ball™ Support.

2. Carefully unpack the BEAVER BLADE. Wear gloves when handling the BEAVER BLADE— the teeth

are very sharp!

THE 12" BEAVER BLADE

MAY ONLY BE USED WITH 2000 SPRINT

®.

OR LATER (YELLOW FRAME) OR

ANY STANDARD, PRO OR COMMERCIAL MODEL DR

TRIMMER/MOWER

™

. THE 12" BEAVER BLADE

IS NOT DESIGNED TO BE MOUNTED ON SPRINT

MODELS MANUFACTURED BEFORE 2000

(ORANGE FRAME), OR COMPACT MODELS.

PLEASE NOTE BEFORE INSTALLING THE 12" BEAVER BLADE:

• DO NOT USE THE STANDARD MOW-BALL™ SUPPORT MOUNTING BOLT FOR MOUNTING

THE 12" BEAVER BLADE AS SERIOUS INJURY MAY RESULT. USE THE HARDENED
MOUNTING BOLT SUPPLIED.

• DO NOT USE HEIGHT ADJUSTMENT DISKS OR LINE PLATES WHEN USING THE 12" BEAVER

BLADE. THE HEAT CREATED BY THE FRICTION OF THE BLADE MAY DAMAGE THEM.

BEFORE PERFORMING ANY MAINTENANCE PROCEDURE, STOP THE ENGINE AND DISCONNECT THE
SPARK PLUG WIRE(S).