Cub Cadet 59A40003727 Manual De Usuario

•  Stop the tractor engine and set the tractor’s parking brake 

before leaving the operator’s seat. Proceed to “Installing the 
Front Loader” in this section.

If an overhead lift is not available, the front loader cylinders can be 
used to position the loader for installation. To position the loader, 
proceed as follows:
•  Start the tractor and carefully drive the tractor to position it 

along the right side of the front loader, facing in the opposite 
direction of the loader.

iMPOrTanT: Stop the tractor engine. Set the tractor’s parking 
brake before leaving the operator’s seat.
•  Remove the four protective caps from the male couplers at 

the free ends of the hydraulic hoses.

•  Locate the color coded protective plugs in the female 

hydraulic couplers on the lower right side of the tractor, just in 
front of the right/rear tire. Refer to Figure 8.

•  Using the color coded plugs and matching color coded 

washers on the loader hoses to guide you, remove the plugs 
and connect each loader hose to the appropriate hydraulic 
coupler. Refer to Figure 8.

nOTe: if for any reason the color coded plugs of the outlets 
and/or caps and washers of the hoses are unavailable or incor-
rect, follow the routing of each hydraulic hose/tube to the loader 
cylinders to determine the loader connection of each hydraulic 
line. Use the following information to determine the appropriate 
hose to hydraulic outlet connection. Working from the right side of 
the tractor, facing the hydraulic outlets, proceed as follows:
Outlet #1 (lower left) - connect the hydraulic line from the piston 
ends of the bucket cylinders (roll back bucket).
Outlet #2 (upper left) - connect the hydraulic line from the cylinder 
body ends of the bucket cylinders (dump bucket).

•  Check for ties that may be installed end to end around both of 

the boom cylinders. Cut and remove the ties if present.

iMPOrTanT: Re-start the tractor and perform the hydraulic test 
described below in 

tion” to assure that all implement control lever movements result 
in the loader movements described. if loader movements do not 
respond correctly, turn the tractor’s engine off, set the parking 
brake and recheck all hydraulic connections as described above. 
loader control movements must be correct before proceeding.
iMPOrTanT: if you were unable to connect the pistons of the 
two bucket cylinders to the bucket rear mounting brackets as 
instructed earlier, use the tractor’s implement control lever to 
extend the pistons as needed and connect the cylinders now. 

Warning: Use extreme caution when perform-
ing the loader boom cylinder charging procedure.

nOTe: For packaging purposes the two boom cylinders are 
fully collapsed. this results in the loader masts being positioned 
beyond their normal vertical position, which causes the loader’s 
center of gravity to be shifted rearward of normal. Consequently 
the loader hitch arms may not pivot downward when initially 
extending the boom cylinders pistons. When performing the 
initial priming of the boom cylinders, it will be necessary to apply 
downward force on the front of the bucket (e.g.; placing weight on 
bucket shave plate; an assistant applying downward pressure on 
the bucket) to pivot the hitch arms downward and raise the loader 
masts.
•  While observing the hoses to ensure they do not become 

pinched or stretched, slowly and carefully move the imple-
ment control lever rearward to extent the boom cylinders. The 
loader hitch arms should pivot downward toward the ground 
and raise the bottoms of the masts.

Lower Boom

(#3-Blue)

Raise Boom

(#4-Green)

Dump Bucket

(#2-Yellow)

Curl Bucket

(#1-Red)

Hydraulic Outlets