Jeep 50-0284x-015 Series Manual De Usuario

                                                                                                3

 

   I. PREPARATION OF VEHICLE INTERIOR 

 

 

1. Using the rear edge of O.E. console as a reference 

location, carefully measure & trim headliner as 
shown. Use a razor knife to score the first layer 
and scissors to cut remaining layers. Caution: 
Before cutting headliner material, check for  
wiring or other componentry above headliner. 
Cut only where indicated. Wear safety goggles 
when cutting headliner material.  Make sure 
that the 9" & 7" cuts are centered left to right in 
vehicle. See Figure 1.                                             
DO NOT OVERCUT HEADLINER. 

 2. Scribe a center line on the sheet metal roof of     
     the vehicle from front to rear of opening in  
     headliner. This will be used for bracket 

alignment.   See Figure 1.  

 
 
 
 
 
3.  Remove and retain (1) one screw which secures 

front O.E. console. Pull downward to release 
console. See Figure2. 

 
 
 
 
 

 
 
 

4.  Using a 3/8" drill bit, make an access hole in rear 

of plastic bracket. Caution: Drill toward rear 
of vehicle. See Figure 3. 

5.  Construct a jumper harness that will connect the 

vehicle’s dome light wires to the lights in video 
system.  Connect the white wire to the O.E. pink 
wire. Connect the black wire to the O.E. 
yellow/green wire. See Figure 3.                                                   

6.  Using a test light, test function  of lights. 
7.  Install O.E. console. 

 

 

  

    

FIGURE 2 

FIGURE 1 

FIGURE 3