Connect Tech BLUE HEAT/NET SYNC CTIM-00044 Manual De Usuario
Connect Tech Blue Heat/Net Sync User Manual
26 Revision 0.03
Save setting changes to non-volatile flash storage
Download a new operating system via TFTP and flash,
(uClinux) and loader/SCM image.
Command Details
boot
Syntax:
boot [mode=] [file=] [delay=]
Description:
This command establishes the Blue Heat/Net Sync boot-up mode. For a detailed
description of the boot-up process of the Blue Heat/Net Sync, see
description of the boot-up process of the Blue Heat/Net Sync, see
Options:
mode=
A comma-separated list of the following sub-options. Each sub-option is
preceded by either a + or a – to indicate if the sub-option is enabled or disabled.
±flash Enables or disables the ability to boot from the flash memory.
±bootp Enables or disables the ability to obtain the boot-up information from a
Server.
±tftp Enables or disables the ability to download and boot from a file located on
a Server.
±bootp Enables or disables the ability to obtain the boot-up information from a
Server.
±tftp Enables or disables the ability to download and boot from a file located on
a Server.
file=
This option specifies the default file name used for the boot-up (if TFTP boot is
enabled) and also the default file name when using the flos command.
This can be any sequence of characters up to 128 characters in length. (The
default is BHNuClinux_vvv.gz, where vvv is the current version number of the
“Operating System image”).
This option specifies the default file name used for the boot-up (if TFTP boot is
enabled) and also the default file name when using the flos command.
This can be any sequence of characters up to 128 characters in length. (The
default is BHNuClinux_vvv.gz, where vvv is the current version number of the
“Operating System image”).
delay=
This sets the time duration for accessing the SCM application. It can be set from
2 to 30 seconds, the default is 30. (See the section
This sets the time duration for accessing the SCM application. It can be set from
2 to 30 seconds, the default is 30. (See the section
cfg
Syntax:
cfg [port=] [timeout=] [password=] [prompt=] [file=]
Description:
Establishes the settings used by the SCM application to
modify its behavior.
Options:
port=
Specifies the port number to scan for a password to gain entry in the SCM.
N = Scan just port N (N=1 to the number of ports on the unit).
255 = Scan all ports on the unit (default unless unit has programmable line
interfaces).
timeout=
Specifies the time duration allowed for a TCM (via telnet) session to be idle (no
activity) before the session is terminated.
0 to 1092 minutes
(default = 5)
Note: A setting of zero allows infinite timeout.
NOTE: The TCM function is currently not available with this
product.
Specifies the time duration allowed for a TCM (via telnet) session to be idle (no
activity) before the session is terminated.
0 to 1092 minutes
(default = 5)
Note: A setting of zero allows infinite timeout.
NOTE: The TCM function is currently not available with this
product.