Cisco Systems C9800 GA Manual De Usuario
4
4-11
Network Setup options
Protocol Setup options
AppleTalk Zone
List of zones
The Fiery searches the network for AppleTalk zones in your network segment. Scroll
through the list to select the AppleTalk zone in which you want the Fiery to appear.
If your segment has only one zone, the Fiery is assigned to that zone
through the list to select the AppleTalk zone in which you want the Fiery to appear.
If your segment has only one zone, the Fiery is assigned to that zone
automatically.
The message “No AppleTalk zone found” may mean your network has no zones, or the
network cable is not connected (see
network cable is not connected (see
).
TCP/IP Setup options
When you set an IP address, subnet mask, or gateway address for the Fiery during
Setup, you can allow the Fiery to get these addresses automatically from a DHCP or
BOOTP server. First, turn on or restart the Fiery and allow it to reach Idle. Make sure
the DHCP or BOOTP server is running, and then perform Fiery
Setup, you can allow the Fiery to get these addresses automatically from a DHCP or
BOOTP server. First, turn on or restart the Fiery and allow it to reach Idle. Make sure
the DHCP or BOOTP server is running, and then perform Fiery
Setup.
To configure the Fiery, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
Network Setup
Protocol
Setup
AppleTalk Setup
Enable AppleTalk
Yes/No [Yes]
Select Yes if you have an AppleTalk network connected to the Fiery. This setting
enables the Fiery to communicate over AppleTalk networks.
enables the Fiery to communicate over AppleTalk networks.
To configure the Fiery for TCP/IP, choose TCP/IP Setup.
Choose Ethernet Setup and enter the appropriate settings. Choose each network
type you use (Ethernet) and enter the appropriate settings.
type you use (Ethernet) and enter the appropriate settings.