CAT Titan 250 Manual De Usuario
Turbomachinery Package Specification
Titan
250 Generator Set
a post-lube cycle to protect the gas turbine and driven equipment bearings from thermal
damage.
If the shutdown is the result of fire being detected, the turbine is brought to a complete
stop and the start of the post lube cycle is delayed for 10 minutes, unless an operator
intervenes.
damage.
If the shutdown is the result of fire being detected, the turbine is brought to a complete
stop and the start of the post lube cycle is delayed for 10 minutes, unless an operator
intervenes.
9.4.4
Vibration and Temperature Monitoring
In addition to the T5 thermocouples, the system provides continuous monitoring of
temperature and vibration levels at key package locations. Refer to the Specification
Table for details.
temperature and vibration levels at key package locations. Refer to the Specification
Table for details.
9.5
TT4000 Display and Monitoring System
The TT4000 display and monitoring system provides extensive data collection and
display capabilities. On a typical project, two standard versions of the product are used.
display capabilities. On a typical project, two standard versions of the product are used.
TT4000
is the fully featured version with extensive data collection and display capability.
It is installed in a high performance industrial grade personal computer (PC), in either a
desktop or a console panel mounted version. It runs on the Windows 2000 operating
system. The hardware is not rated for hazardous areas and must be installed in a non-
hazardous area, typically a control room. Note: this full TT4000 version is required for the
engine performance map option.
desktop or a console panel mounted version. It runs on the Windows 2000 operating
system. The hardware is not rated for hazardous areas and must be installed in a non-
hazardous area, typically a control room. Note: this full TT4000 version is required for the
engine performance map option.
TT4000S
is a reduced version of the product specifically designed for the onskid
interface. It is installed in a special industrial grade PC that is approved for use in both
NEC Division 2 and CENELEC/ATEX Zone 2 areas. It runs on the embedded Windows
XP operating system. Due to the environment, it uses no moving media such as disk
drives, so data storage is limited. It displays data but without the graphics features of the
full TT4000 version.
NEC Division 2 and CENELEC/ATEX Zone 2 areas. It runs on the embedded Windows
XP operating system. Due to the environment, it uses no moving media such as disk
drives, so data storage is limited. It displays data but without the graphics features of the
full TT4000 version.
9.5.1
TT4000 Display Screens
A menu bar at the left of each screen allows navigation to any other screen. A status bar
at the top of every screen displays up to four alarm conditions. Standard display screens
include:
at the top of every screen displays up to four alarm conditions. Standard display screens
include:
• Operation Summary (complete package data, Figure 15)
• Generator Summary (generator operating data)
• Temperature Summary (all monitored temperature values)
• Vibration Summary (all monitored vibration values)
• Alarm Summary
• Discrete Event Log
• Strip Chart Display (real time data, Figure 16)
• Historical Data Display (strip chart format)
• Program Constants
• Generator Summary (generator operating data)
• Temperature Summary (all monitored temperature values)
• Vibration Summary (all monitored vibration values)
• Alarm Summary
• Discrete Event Log
• Strip Chart Display (real time data, Figure 16)
• Historical Data Display (strip chart format)
• Program Constants
Optional Display Screens:
• Gas Turbine Performance
Customized screens can be provided to display other product specific information.
© 2008 Solar Turbines Incorporated. All rights reserved.
TPS250GS/908 - Preliminary
34