Cambridge SoundWorks NEWTON MC650HD Manual De Usuario
10
Warning About Excessive Amplifier Distortion:
Operating a receiver (of any power rating) beyond its
maximum undistorted output level creates distortion –
added high frequency sound not part of the musical program.
Distortion dramatically increases the internal operating tem-
perature of a speaker and will eventually cause the speak-
er’s failure due to burned or melted internal parts. While
Cambridge SoundWorks includes the most heat-tolerant
parts commensurate with good acoustic design, the
speaker’s Limited Warranty against defects in materials or
workmanship does not apply to parts that fail from long-
term operation at very high temperatures.
Enclosure Cleaning
The speaker enclosures can be cleaned with a soft, damp
cloth or mild cleaner.
Brush or vacuum the grille panels with a soft brush
attachment to your vacuum cleaner.
Specifications
Dimensions: 25-3/8" H x 7-1/8" W x 3-15/16" D
Weight: 14-1/2 pounds each
Impedance: nominal 8 ohms
Recommended amplifier power range: 20W – 100W RMS
per channel.
Frequency Range: 80Hz – 24kHz.
Woofer Type: 4 x 3-1/2" with co-injection molded composite
cones and butyl-rubber surrounds.
Tweeter Type: 1/2" aluminum dome with ferrofluid-damping
and neodymium magnet.
Crossover: 2-1/2 way, series-connected with selectable
wall-mounting compensation.
Enclosure: High-density pressure-cast aluminum with
molded-composite baffle.
SPECIFICATIONS
2a
2b
1
1/4"
BRAND
AF6
TM
ALLIGATOR
®
Solid-Wall Anchors
Drill 1/4" diameter hole — minimum hole
depth
depth
1
1
/
2
". Insert anchor and tap flush.
Place item over anchor. Insert screw and
tighten flush. For best results use screw
gun for installation in solid walls.
tighten flush. For best results use screw
gun for installation in solid walls.
In walls of minimum thickness 3/8",
screw opens anchor and locks securely.
screw opens anchor and locks securely.
Patented under U.S. Patent Nos. 4,752,170 and
5,161,296; and foreign counterparts thereof.
Other patents pending. TOGGLER and typeface,
and ALLIGATOR are worldwide registered
trademarks of Mechanical Plastics Corp.
© 2002 MPC
®
Appendix