Aprilaire Paint Remover 8028 Prospecto

1.   120 volts may cause serious injury from electrical shock. Leave

power to all system components disconnected until installation
is complete

1. Installation must be done in accordance with the NEC and all

other applicable local codes.

2. To prevent excessive transformer heating, do not power more

than the recommended number of dampers to a transformer.

Set to SINGLE SUPPLY when used:

• in a two zone system when there are no more than 10 dampers in either ZONE A or ZONE B.

Size the transformer for the zone with the most dampers.

• when there are no more than 10 total dampers wired to ZONE A plus ZONE B. Size the transformer

for the total number of dampers connected to both zones.

When set to SINGLE SUPPLY, wire transformer to “POWER A” terminals.  Refer to Diagram 2 on the
back for wiring.

Set to SEPARATE SUPPLIES for all other applications.  Wire transformers to “POWER A” and “POWER B”
terminals.  Refer to Diagram 1 on the back. 

ZONE A

ZONE B

SINGLE

SINGLE 

SUPPLY

SEPARATE 

SUPPLIES

ZONE A –  5 AMP

ZONE B –  5 AMP

SPARE FUSE –  5 AMP

5

4

3

2

1

ZONE B

DAMPERS

ZONE A

DAMPERS

1

2

3

4

5

POWER 

A

POWER 

B

ZA

ZB

C

NO

C

NO

Damper Power Input(s)
from Transformers

Dampers Wired to ZONE A and ZONE B Terminals

Control Input(s) from
Zoned Comfort Control
Panel

ZA LED lights when 24-volts is applied to the ZONE A control input.

ZB LED lights when 24-volts is applied to the ZONE B control input.