American Power Conversion AIRACPA4000 Manual De Usuario
®
®
®
®
ADDENDUM
NetworkA
IR ACPA4000
5
Using the Network Management Card Wizard
Configuring the required TCP/IP settings
To configure the Network Management Card’s required
TCP/IP
settings
remotely:
1. Contact your network administrator to obtain valid
TCP/IP
settings.
2. From the
Start
menu, launch the Wizard application. The Wizard
automatically detects any unconfigured Network Management Cards.
3. Select the
Express (Recommended
) option from the “Installation
Options” screen, and then click
Next >
.
4. Select the
Remotely (over the Network)
option from the “Express
Configuration” screen, and then click
Next >
.
5. When the Wizard prompts you for the
TCP/IP
settings, configure the
settings (
System IP
,
Subnet Mask
, and
Default Gateway
addresses).
6. Select the
Start a Web browser when finished
option to connect over
the Web to the NetworkAIR PA Portable Air Conditioner. This launches
the default Web browser. Click
the default Web browser. Click
Finish
and wait for a few seconds to let
the Management Card restart, which will not interrupt power to the air
conditioner.
conditioner.
7. After you enter the correct,
IP
-formatted information, click
Finish
to
transmit the
TCP/IP
settings. The Wizard checks to see if the System
IP
address you entered is in use on the network. If it is discovered as an
IP
address in use, enter a valid
IP
address, click
Finish
, and follow the
on-screen instructions.