Motorola Automobile Accessories F5218 Manual De Usuario
10
MW810 Mobile Workstation Vehicle Installation Manual
Equipment Ventilation
The display, keyboard and CPU Box are designed to operate properly in an ambient
temperature range of -22°F to 158°F (-30°C to +70°C). The MW810 Mobile Workstation
CPU must be installed in an area with adequate air flow to allow for proper ventilation.
Installers must install the CPU in an unobstructed location in order to allow proper air flow
Installers must install the CPU in an unobstructed location in order to allow proper air flow
(see Figure 5). It is imperative to avoid installing the CPU in an enclosure or next to heat
generating equipment such as: radio transmitters, power amplifiers or a cabin heater.
Drilling Holes
• Where possible, use existing holes in the fire-wall, the trunk wall and the channels above
or beneath the doors. Run cables parallel to existing car cables if appropriate.
• When holes must be drilled, verify that other wiring, break lines or gas lines are not
damaged.
• When drilling a hole in the roof, take care not to snag the roof liner.
• To prevent rusting after drilling, remove all metal burrs and residue, and completely clean
• To prevent rusting after drilling, remove all metal burrs and residue, and completely clean
the area to ensure that all steel dust is removed.
Clear 0.8”
(20 mm)
Air Inlet to Fans
Air Outlet
from Fans
Clear 0.8” (20 mm)
Clear 0.8” (20 mm)
Clear 0.8
” (20
mm)
Figure 5
Clear Ventilation Area Around the CPU Box
Air Inlet to Fans
Air Outlet from Fans