Brocade Communications Systems Brocade ICX 6650 6650 Manual De Usuario

Enabling IPv6 on an interface to which an ACL will be applied

•

renum-command

•

renum-result

•

renum-seq-number

•

router-advertisement

•

router-renumbering

•

router-solicitation

•

time-exceeded

•

unreachable

NOTE
If you do not specify a message type, the ACL applies to all types ICMP messages types. 

Enabling IPv6 on an interface to which an ACL will be applied

Before an IPv6 ACL can be applied to an interface, it must first be created, and then IPv6 must be 
enabled on that interface.

To enable IPv6 on an interface, enter ipv6 enable at the Interface level of the CLI, or assign an IPv6 
address to the interface, as described in Brocade ICX 6650 Administration Guide.

For example:

These commands enable IPv6 on Ethernet interface 1/1/1 ready for an IPv6 ACL to be applied.

Syntax: ipv6 enable

When issued at the Interface Configuration level, this command enables IPv6 for a specific 
interface.

Applying an IPv6 ACL to an interface

As mentioned in 

 on page 127, IPv6 ACLs are supported on the following 

devices:

•

Gbps Ethernet ports

•

10 Gbps Ethernet ports

•

Trunk groups

•

Virtual routing interfaces

To apply an IPv6 ACL to an interface, enter commands such as the following.

Brocade(config)# interface ethernet 1/3/1
Brocade(config-if-e100-1/3/1)# ipv6 traffic-filter access1 in

Brocade(config)# interface ethernet 1/1/1
Brocade(config-if-e10000-1/1/1)# ipv6 enable