Bunn LPG Manual De Propietario

4

 

The grinder has an attached cordset and requires 2-wire, grounded service rated 120 volts ac, 15  amp, single 

phase, 60 Hz for 120V models; 100 volts ac, 15 amp single phase, 50Hz for 100V models. 

P1028

P1029

 

OFF - (upper position) Switching to this position stops all operation of 

the grinder.

 

ON  - (middle position) The switch will return to this position after a 

grind cycle has begun and will remain in this position after grinding has 

ceased.

 

START - (lower, momentary position) Pressing the switch to this position 

and releasing initiates a grind cycle.

- Switching to this position allows beans to be ground from the left 

hopper.

- Switching to this position allows beans to be ground from the 

right hopper.

27091 042211

Bunn-O-Matic® Corporation recommends that preventive maintenance be performed at regular intervals. 

Maintenance should be performed by a qualified service technician. For Technical Service, contact Bunn-O-

Matic® Corporation at 1-800-263-2256.

Weekly Cleaning plus replace the dechaffer assembly.

1. On grinders with slide plates check the slide plates and clean.

2. Inspect and clean/replace burrs and grind chamber if necessary.

3. Adjust the burrs and grind time to your specifications for particulate size and throw weight.

• This appliance must be installed in locations where it can be overseen by trained personnel.

• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.

• Appliance shall not be tilted more than 10° for safe operation.

• An electrician must provide electrical service as specified in conformance with all local and national codes.

• This appliance must not be cleaned by water jet.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental 

capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of 

this appliance by a person responsible for its safety.

• Children should be supervised to ensure they do not play with the appliance.

• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with 

a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.