Bunn VP-17 1, 2, 3 (120 Volt) Manual De Propietario

Page 5

CAUTION - The brewer must be disconnected from the power source throughout the initial set-up, except when 

specified in the instructions.

1.  Insert an empty funnel into the funnel rails.

2.  Place an empty decanter under the funnel.

3.  On "B" Models, place the heater switch of the brewer in the "OFF" (lower) position and connect the brewer to 

the power source.

4.  Pour three pitchers of tap water into the screened area on top of the brewer.  Allow approximately two minutes 

between pitchers for water to flow into the tank.  While the third pitcher of water is entering the tank, the tank 

will fill to capacity and the excess will flow from the sprayhead, out of the funnel, and into the dispenser.

5.  When the flow of water from the funnel stops, place the heater switch of the brewer in the "ON" (upper) posi-

tion and wait approximately twenty minutes for the water in the tank to heat to the proper temperature.  Some 

water will drip from the funnel during this time; this is due to expansion and should not occur thereafter.

6.  Pour one pitcher of tap water into the screened area on top of the brewer.

7.  After water has stopped flowing from the funnel,  allow the water in the tank  to reheat to the proper tem-

perature.

8.  Empty the decanter. The brewer is now ready for use in accordance with the coffee brewing instructions.

1.  Insert a BUNN

®

 filter into the funnel.

2.  Pour the fresh coffee into the filter and level the bed of grounds by gently shaking.

3.  Slide the funnel into the funnel rails.

4.  Place an empty dispenser beneath the funnel.

5.  Pour one pitcher of tap water into the screened area on top of the brewer.

6.  When brewing is completed, simply discard the grounds and filter.

1.  The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all 

surfaces on Bunn-O-Matic equipment.

2.  Check and clean the sprayhead.  The sprayhead holes must always remain open.

3.  With the sprayhead removed, insert the deliming spring (provided) all the way into the sprayhead tube.  When 

inserted properly, no more than two inches of spring should be visible.  Saw back and forth five or six times.

NOTE – In hard water areas, this may need to be done daily.  It will help prevent liming problems in the brewer 

and takes less than a minute.

46720  052512