Wyse Network Router 1 Manual De Usuario

Setting Up the Thin Client

b. Type the thin client IP address or DNS name in the Name or address of host 

providing LPD box.

c. Type the printer name (assigned in “Configuring LPD Services” ) in the Name of 

printer on that machine box.

d. Click OK, and then click NEXT.

3. After you have selected the printer, you can perform your normal printer setup for the 

application server. For example, select the manufacturer printer type and printer name.

1. Navigate to Control Panel | Administrative Tools | Services and ensure the 

Microsoft TCP/IP Printing service is installed. If it is not, install it using the Microsoft 
installation instructions.

2. Add the thin client as the LPD printer by completing the following:

a. Navigate to Control Panel | Printers | Add Printers | Local Printer | Create a 

new port and select LPR PORT.

If you do not see LPR Port, ensure that the Microsoft TCP/IP Printing service 
is installed correctly.

b. Type the thin client IP address or DNS name in the Name or address of host 

providing LPD box.

c. Type the printer name (assigned in “Configuring LPD Services” ) in the Name of 

printer on that machine box.

d. Click OK, and then click NEXT.

3. After you have selected the printer, you can perform your normal printer setup for the 

application server. For example, select the manufacturer printer type and printer name.

The Touch Screen Setup allows configuration of touch screens that are connected to the 
thin client (USB and Serial). The Touch Screen Setup window is automatically invoked 
when the terminal detects that a touch screen is attached through a USB port and the 
setup (or calibration) has not been performed. In addition, the calibration sequence is 
executed whenever Touch Screen is selected from the Desktop menu.

The Touch Screen desktop menu item is grayed out until a touch screen is 
connected. All ELO USB-based touch monitors and the M150-USB touch 
monitor from MicroTouch are supported.

The Touch Setup window prompts you to touch two circles on the screen to make the 
necessary calibration adjustment. Once calibrated, the adjustment values are saved in the 
local terminal NVRAM until the system is reset to factory default, or another type of touch 
monitor is connected.