BMW 2008 M5 Sedan Manual De Propietario

Under t

210

Do not add engine oil. Before continuing to
drive, note the recalculated remaining mile-
age until the next oil change service, refer to
Service requirements on page

. Have the

system checked as soon as possible.

Adding engine oil

Do not add oil until a value slightly above the
minimum of 0.0 US quarts/liters is displayed by
the oil level measurement. In this area a mes-
sage is also shown on the Control Display.

Add oil within the next 125 miles/200 km,
otherwise the engine could be damaged.

Add a maximum of 1 US quart/1 liter of oil, oth-
erwise the engine may be damaged by adding
too much oil.
Add at least 0.5 US quart/0.5 liter of oil, other-
wise the oil level check cannot reliably display
the current oil level.

Please conduct a fast measurement after
adding engine oil to check the oil quantity

added and to update the display.

Continuous exposure to used oil has
caused cancer in laboratory testing.

For this reason, any skin areas that come into
contact with oil should be thoroughly washed
with soap and water.
Keep oil, grease etc. out of reach of children and
observe the warnings on the containers to pre-
vent health risks.

Oil change

Have oil changed only at your BMW center or
at a workshop that works according to BMW
repair procedures with correspondingly trained
personnel.

Approved engine oils

The quality of the engine oil selected has critical
significance for the operation and service life of
an engine. BMW continuously approves spe-
cific oils after confirming their suitability for use
in its vehicles with extensive testing.

Do not use oil additives, as these may
result in engine damage.

Your BMW center will be happy to answer
detailed questions on BMW High Perfor-

mance Synthetic Oil or approved synthetic
oils.

You can also call BMW of North America at
1-800-831-1117 or visit the website at
www.bmwusa.com to obtain this information.

Viscosity grades

Viscosity is a measure of an oil's flow rating and
is specified in SAE grades.

Approved oils belong to the SAE grade
10W-60.

Alternative oil grades

If BMW High Performance Synthetic Oil is
unavailable, you can add small quantities of
other synthetic oils between oil changes.
Only use oils with the following specifications:

Viscosity
preferred: SAE 10W-60;
alternative: SAE 10W-40, SAE 5W-50 or
SAE 10W-50

Specification
API SJ/CF, API SK/CF or higher

Low ambient temperatures

The oils used by BMW from the factory for your
vehicle model can be used at virtually all ambi-
ent temperatures. However, if the vehicle is
operated for a longer period at temperatures
below –4

7/–206, your BMW center will be

happy to recommend a suitable oil.