BMW 2011 ActiveHybrid 750i Manual De Propietario

2.

For better accessibility, tilt the backrest
back slightly.

3.

Mount the child restraint fixing system; refer
to the operating instructions of the system.

4.

Ensure that both LATCH anchors are prop‐
erly connected.

5.

After mounting, move the backrest back up
slightly so that the child restraint fixing sys‐
tem rests lightly against the backrest.

Depending on the vehicle equipment, there are
two outer or three mounting points for child re‐
straint fixing systems with a tether strap.

LATCH mounting eyes
Only use the mounting eyes for the upper

LATCH retaining strap to secure child restraint
fixing systems; otherwise, the mounting eyes
could be damaged.◀

Retaining strap
Make sure the upper retaining strap does

not run over sharp edges and is not twisted as it
passes to the top anchor. Otherwise, the strap
will not properly secure the child restraint fixing
system in the event of an accident.◀

1 Direction of travel
2 Head restraint.
3 Hook for upper retaining strap
4 Mounting point/eye
5 Rear window shelf
6 Seat backrest
7 Upper retaining strap

1.

Remove the mounting point cover.

2.

Raise the head restraint. Do not change the
middle head restraint*.

3.

Guide the upper retaining strap between the
supports of the head restraint.
Guide it over the head restraint of the middle
seat.

4.

Attach the hooks of the retaining strap to the
mounting eyes.

5.

Tighten the retaining strap by pulling it
down.

6.

Lower the head restraint.

Seite 64

64

Online Edition for Part no. 01 41 2 603 958 - 03 10 500