BMW 2011 328i Sedan Manual De Propietario

 107

The integrated universal remote control can 
replace as many as three hand-held transmit-
ters for various remote-controlled devices, 
such as garage doors and gates or lighting sys-
tems. The integrated universal remote control 
registers and stores signals from the original 
hand-held transmitters.
The signal of an original hand-held transmitter 
can be programmed on one of the three mem-
ory buttons

1. After this, the programmed 

memory button

1 will operate the system in 

question. The LED

2 flashes to confirm trans-

mission of the signal.
Should you sell your vehicle one day, be sure to 
delete the stored programs beforehand for your 
safety, refer to page

To prevent possible damage or injury, 
before programming or using the inte-

grated universal remote control, always inspect 
the immediate area to make certain that no peo-
ple, animals or objects are within the pivoting or 
travel range of the device being operated. Com-
ply also with the safety instructions supplied 
with the original hand-held transmitter.

<

If this symbol appears on the package 
or in the instructions supplied with the 
original hand-held transmitter, you can 

assume that the radio remote control device will 
be compatible with the integrated universal 
remote control.
For additional information, please contact your 
BMW center or call: 1-800-355-3515.
You can also obtain information on the 
Internet at: 
www.bmwusa.com or 
www.homelink.com. 
HomeLink is a registered trademark of Johnson 
Controls, Inc.

<

1 Memory buttons
2 LED

1.

Switch on the ignition, refer to page

2.

When starting operation for the first time: 
press the left and right memory buttons

1 

for approx. 20 seconds until the LED

2 

flashes rapidly. The three memory buttons 
are cleared.

3.

Hold the original hand-held transmitter at a 
distance of approx. 4 to 12 in/10 to 30 cm 
from the memory buttons

1.

The required distance between the 
hand-held transmitter and the mem-

ory buttons

1 depends on the system of 

the respective original hand-held transmit-
ter used.

<

4.

Simultaneously press the transmit key on 
the original hand-held transmitter and the 
desired memory button 

1 on the integrated 

universal remote control. The LED 

2 flashes 

slowly at first. As soon as the LED

2 flashes 

rapidly, release both buttons. If the LED

2 

does not flash rapidly after approx. 15 sec-
onds, alter the distance and repeat this 
step.

5.

To program other original hand-held trans-
mitters, repeat steps 3 and 4.

The corresponding memory button 

1 is now 

programmed with the signal of the original 
hand-held transmitter.

Online Edition for Part no. 01 41 2 604 582 - © 02/10 BMW AG