BT EQUINOX 1350 Manual De Usuario
100
BT Equinox 1350 – Edition 4.1 – 27.09.05 – 6576
If you experience any problems, please call the Helpline on 0870 605 8047
Access code and entering a pause
If you are connecting your BT Equinox 1350 to a switchboard/PBX you may need to prefix
stored numbers with an access code (e.g. 9) in order to get an outside line. So that the
switchboard has time to pick up an outside line, you may also need to add a Pause after
the access code.
stored numbers with an access code (e.g. 9) in order to get an outside line. So that the
switchboard has time to pick up an outside line, you may also need to add a Pause after
the access code.
A pause is entered when storing a number in the phonebook (see page 26) or PABX access
code (see page 76) by pressing and holding the
code (see page 76) by pressing and holding the
button on the handset or base until
the display shows
P
.
Dialling mode
With some switchboards/PBXs you may need to switch the dial mode from Tone to Pulse,
otherwise you should not need to adjust this setting.
otherwise you should not need to adjust this setting.
1. Press
MENU
then scroll
to
Base Settings
and press
OK
. Press
to highlight
Dial
Mode
then press
OK
.
2. Press
or
to highlight the setting you want. Press
OK
to confirm.
General information