Elica ECL630S2 Instruccion De Instalación
8
Installation
Installation - Ducting version
•
If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to
rear wall. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage
and debris. Select a flat surface for assembling the unit.
Cover that surface with a protective covering and place
all canopy hood parts and hardware in it.
range from cabinet opening to provide easier access to
rear wall. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage
and debris. Select a flat surface for assembling the unit.
Cover that surface with a protective covering and place
all canopy hood parts and hardware in it.
• Determine and mark the centerline on the wall where the
canopy hood will be installed.
• Select a mounting height comfortable for the user and
mark on wall.
• Tape template, matching center-line and hood bottom.
INSTALL HOOD ONTO WALL
IMPORTANT: Framing must be capable of supporting
up to 150 lbs.
up to 150 lbs.
• Locate at least.2 vertical studs at the wood support.
• Center the supplied wood support, left to right and below
the 15 3/8" marked line.
• Secure the wood support to 2 or more vertical studs,
using at least 2 of the 4 supplied long screws.
IMPORTANT: Screws must penetrate at least 1 1/2" into
vertical studs. Countersink screws into support.
Note: The mounting screws must remain in their original
shipping location. These screws are positioned to
engage the keyhole slots in the back of the hood.
shipping location. These screws are positioned to
engage the keyhole slots in the back of the hood.
• Adjust depth of original mounting srcrews in the wood
support until they protrude 1/4" forward. This 1/4" gap
will provide clearance to hang the hood.
will provide clearance to hang the hood.
Install Transition Onto Top of Hood
IMPORTANT: Remove shipping tape from damper and
check that damper moves freely.
check that damper moves freely.
• Place the transition piece over the hood exhaust and
secure with 4 screws provided.
• Use duct tape to seal the connection. Check to be sure
the damper moves freely.
Hang hood on wood support
• Lift the hood and hold close to the installation location.
Route house wiring through the knockout and into the
junction box.
junction box.