Crossover WHWF09810M Instruccion De Instalación
9. Assemble the two fitting-adapter washers from the kit, using a ¾” electrical knockout fitting
(supplied by installer) in the hole in the back cabinet through which the top-left (viewed
from the rear) shipping security screw was installed.
from the rear) shipping security screw was installed.
10. Feed the liquid supply harness leads through the ¾” electrical knockout fitting, and into an
appropriate external protective wireway (EMT, metallic sheath, or other code-compliant
wireway) to the liquid supply pump (Fig. 6). NOTE: It is the installer’s responsibility to
ensure that installation methods comply with all applicable codes.
wireway) to the liquid supply pump (Fig. 6). NOTE: It is the installer’s responsibility to
ensure that installation methods comply with all applicable codes.
11. Plug the liquid supply harness into connector CN6 located at the top-left vertical edge
(viewed from front of machine) of the power module inside the washer (Fig. 7).
12. Re-install the top panel of the machine.
Fig. 6
Fig. 7