Zephyr ZSIE30AS Manual De Propietario

1.  Measure from range top to hood bottom and mark line A.  

(26” minimum from range top).

2.  Plum and mark center line.

3.  Mark mounting height line B. (1-5/16” from line A)

4.   Mark mounting height line C. (13-1/8” from line A)

5.   Mark mounting spread from C/L on line B 12-3/4”

6.  Mark mounting spread from C/L on line C 9-7/16” 

7.  Fasten (2) M6 x 1-1/4” screws into studs on line C.  Do not 

fasten screws all the way. Note: wood blocking may need 
to be added behind the drywall if no studs are present.
Wall anchors may also be used but check local codes 
for compliance. Failure to use suitable wall anchors 
and screws to hold the weight of the hood could result 
in personal injury or damage to cooking surface or 
counter.

8.   Install 8” round duct collar with backdraft damper to top of 

body of hood by (4) M4x8 fl at screws. 

9.  Hang hood onto screws and hand tighten. (FIG. A #1)   Use 

the last M6 x 1-1/4” screws to further secure the hood to the 
wall from inside the hood on line B.

10. Center and attach duct cover bracket to wall below ceiling

or soffi t using (2) M6 x 1” screws.

11.  Install electrical.

12. *Install duct work and duct tape.

13.  Power up hood and check for leaks around duct tape.

14.  Place telescopic duct covers onto hood and extend inner

(top) duct cover upwards and secure to duct cover bracket 
using (2) M4x8” screws.

      *If using hood in recirculating mode you must secure air 

diverter plate onto wall before installing duct work and duct 
covers.  Turn to page10 for more details.

C/L

13-1/8"

9-7/16"

C/L

26" min

Duct Cover
 Bracket

12-3/4"

1-

5/

16"

C

B